Printronix P9000 Series - Manual (Page 35)

2-17 Operation
2. Press MENU DOWN to display the current forms length in lines.
3. Press NEXT or PREV to increase or decrease the forms length in 1-line increments, reĆ
spectively. When the appropriate value is displayed, save it as described below.
4. Press ENTER to select the displayed forms length.
5. Press CLEAR to return to OFFLINE READY.
6. Simultaneously press MENU UP and MENU DOWN to lock the printer configuration.
7. Set the top of form according the the instructions on page 2-9.
8. Close printer cover and place the printer on line.
Selecting Print Mode
During normal operation, the message display indicates the printer is on line and what print
mode is currently selected; for example:
ON LINE
DP AT 10 CPI
1. Place the printer off line and raise the printer cover.
2. Simultaneously press MENU UP and MENU DOWN. ENTER SWITCH NOT
LOCKED will be displayed briefly.
3. Press PRINT MODE; the currently selected print mode will be displayed.
4. Press NEXT, PREV, or PRINT MODE to cycle through the various print mode options.
The following print mode options are available:
Data Processing (DP) at 10, 12, 13.3, 15, and 17.1 cpi
Correspondence (NLQ) at 10, 12 and 15 cpi
High Speed A (HS) at 10, 12, 13.3, 15, and 17.1 cpi
High Speed B (HSB) at 10, 12, 13.3, 15 and 17.1 cpi
High Speed C (HSC) at 10, 12, 13.3, 15 and 17.1 cpi
OCR-A and OCR-B at 10 cpi
NOTE: The control panel actually displays 13 or 17 cpi when 13.3 or 17.1 cpi, respectiveĆ
ly, is selected.
5. When the desired print mode is shown on the display, press the ENTER switch.
6. Press CLEAR to return the printer to off line status. The display will read OFFLINE
READY.
7. Simultaneously press MENU UP and MENU DOWN to lock the printer configuration.
8. Close printer cover and place the printer on line.