Printronix P9000 Series - Manual (Page 146)

Programming 6-48
Line Spacing 1/6 Inch
ASCII Hex Decimal
P-Series SFCC LPI;n
SFCC 2 SFCC 32 SFCC 50
Serial ESC 2 1B 32 27 50
Purpose Sets line spacing to 6 lpi or as set by ESC A.
Comment The value of n can be 6 or 8 only. In LPI mode using P-Series printer protoĆ
col, if n = 6, this command sets line spacing to 1/6 inch. Values of n other than
6 or 8 will cause an error message (Command Line Error Messages are listed
on page 6-3).
SFCC/ESC 2 asserts n/72-inch line spacing as set by SFCC/ESC A (page
6-52). If no distance has been set by SFCC/ESC A, the distance is 1/6 inch.
The control code line spacing selection will override the control panel line
spacing setting.
Example The following example illustrates 1/6-inch line spacing and assumes that a
distance has not been set by ESC A.