Printronix P9000 Series - Manual (Page 44)

Configuration 3-4
Factory Default Configuration Values
Printronix factory default configuration values are shown in Table 3-1. These values are operaĆ
tional when the printer is received. New values can be saved and applied as necessary for each
application, but factory default values remain accessible using the LOAD PARAMETERS
menu. On the Control Panel Configuration Diagrams, factory configuration values are indiĆ
cated by an asterisk (
* ). (The asterisk is not shown on the printer display.)
Table 3-1. Printronix Factory Default Configuration Values
Forms Length
Print Mode
Line Spacing
Ribbon Life
Printer Protocol
Buffer Size
Auto Line Feed
VFU Select
PMD Fault
Perforation Skip
Paper Out
Configuration Factory Default
Parameter Value
11.0 Inches
DP 10 cpi
6 lpi
100
P-Series
2048 Characters
After Full Line
EVFU
Enable
Disable
End of Paper
Printer Select Disable
Define CR Code CR = CR
Paper Advance Switch Print & Paper Advance
Power On State Online
Parallel Interface:
Data Bit 8
Data Polarity
Latch Data On
Fast Busy (Centronics)
Strobe Polarity
Enable
Standard
Leading Edge
Enable
Standard
Serial RS-232 Interface:
Data Protocol
Data Rate
Word Length
Stop Bits
Parity
Bit 8 Function
CD and DSR
Request to Send
Data Term Ready
X-On / X-Off
9600 Baud
8 Bits
One
None
Font Select
Disable
Online and BNF
Online and BNF
PI Line (Dataproducts) Enable
Resp. Polarity Standard
PI Line (Centronics) Disable
Reverse Channel
CTS and DSR
Online and BNF
Disable
Ribbon Size
Job Rate
60
150
When Worn Action
Printer Action
Stop Printer
Disable
Alarm On Fault Enable
Unidirectional Disable
Configuration Factory Default
Parameter Value
Select Subset
Select Set
ASCII
IBM PC
Select Language
IBM PC Graphics
Select SFCC 01 SOH
Control Code 08 Double High
80-9F Hex Control Codes
Control Code 06
Overstrike 8 LPI
Enable
Shuttle Timeout 4 Seconds
Display Language English
Line Width 13.2 Inches
Host Interface Centronics