Printronix P9000 Series - Manual (Page 80)

Graphics 4-12
To Exit the P-Series Plot Mode
When returning to the print mode from the P-Series Plot Mode, an extra line feed should be
included in the data stream to maintain proper print line registration relative to the last line of
plot graphics. If the extra line feed is not included, the first character line after the graphics
data may be truncated, as shown in Figure 4-10.
@ABCDEFGHIJKLMNOPQR
plot data plot data
In this example, a text line follows
plot data, preceded by a single line
terminator code. (Text characters
extend into the range of the previĆ
ously printed plot line and appear
truncated.)
This example shows a text line fol-
lowing plot data, but preceded by an
additional line terminator code.
(Characters are able to be printed
full-height.)
@ABCDEFGHIJKLMNOPQR
Figure 4-10. Truncated Character Line
Combining Graphics and Text
The printer can combine Serial Matrix bit image graphics and characters (text) on the same
line. P-Series graphics and printable symbols cannot be intermixed on the same line.