Printronix P9000 Series - Manual (Page 163)

6-65 Programming
Skip-Over Perforation
ASCII Hex Decimal
P-Series N/A
Serial ESC N n 1B 4E n 27 78 n
Purpose Selects the number of lines (at the current line spacing) for the paper skip" at
the bottom of the perforated page.
where n = 1 to 127 to select the number of lines to skip. If the value of n exceeds
the current forms length, it is ignored.
Comment The actual distance set is the product of n" and the current line spacing. FacĆ
tory default value disables skip-over perforation. The current default value
may be set by the operator. Setting a new forms length (ESC C) resets skip-
over perforation to zero.
This feature is disabled whenever vertical tabs are set.
Skip-over perforation can also be selected from the control panel; however,
vertical tabs within the skip-over perforation zone, as set by the control panĆ
el, are ignored. The control code skip-over perforation setting from the host
computer will override the control panel setting.