Panasonic DP-3510 User Manual
Page 121
121
Troubleshooting
C The service life of the battery is approximately 1 year under normal use.
1
Turn the Power Switch OFF.
Open the Front Cover.
Pull out the Battery Holder located
directly under the Data LED of the
Control Panel.
2
#Remove the Battery.
$Install the new Battery.
NOTE:
When the battery is placed in the
holder ensure the + side is up.
The copier has an internal battery (Product No.: CR2032) which maintains the date and
time. In the event the battery requires replacement, the following message will be displayed.
■
■
■
■
■ Battery Replacement Message
■
■
■
■
■ Battery Replacement Procedure
3
Reinstall the Battery Holder.
4
Ensure to close the Front Cover.
Turn the Power Switch ON.
Set the date and time.
(See page 69)
Replacing the Battery
ATTENTION
CAUTION
!
• THIS PRODUCT CONTAINS A LITHIUM BATTERY. DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY
REPLACED.
REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO
THE INSTRUCTIONS OF YOUR LOCAL SOLID WASTE OFFICIALS.
denotes hazards that could result in minor injury or damage to the machine.
Other
s
U90
Data LED
1
2
Data LED
P121_dp4510(pb).p65
7/31/02, 10:51 AM
121