Panasonic DP-3510 - Manual (Page 89)

89
Accessories
Options
B4·FLS
3. How to use
i-ADF
Face-Up
Platen
4
Number
of Copies
5
Staple Position
(ex. $-1)
Face-Down
1
Place the
Original
2 3
Select
SORT/
FINISH
mode Select
Finisher
Mode
Select the type of copy group mode into 2-bin finisher
and press OK.
# SORT
Multiple copies are sorted automatically and
stacked with shift.
$ ROTATE-SORT (Upper bin only)
Copied sets are separated by rotation and exited
onto tray.
% ROTATE-GROUP (Upper bin only)
Grouped copies are rotated and exited onto tray.
& NON-SORT
Copy is stored on the tray.
( PUNCH *
Sorted copies are punched and exited onto tray.
(Except Rotate-Sort and Rotate-Group modes)
) SHIFT-SORT (Lower bin only)
Copied sets are offset and exited onto tray.
* STAPLE-SORT (Lower bin only)
Sorted copies are stapled and exited onto tray.
+ SHIFT-GROUP (Lower bin only)
Grouped copies are offset and exited onto tray.
∗
In the 4 hole punch mode, A3 size
and A4 B size are available.
NOTE
C The above sort modes may not work if you are using gray originals, as this
may cause a memory overflow.
C In such a case, it is recommended either make copies by separate lots
(except staple-sort) or install optional Hard Disk Drive (DA-HD60).
C If output sheets are curled, or not properly aligned, remove the paper from
the paper tray, turn it over, and replace it in the paper tray.
Press
START
P089_dp4510(pb).P65 7/31/02, 10:50 AM 89