Panasonic DP-3510 - Manual (Page 41)

41
NOTE
B4·FLS
Edge/Book/Margin
■ ■ ■ ■ ■ Procedure
Zoom/Effects
∗
Initial setting (Factory setting) can be changed by the function mode.
(See page 62)
∗∗
If a part of the copied image is missing when using the Margin mode,
change the Margin Reduction setting to Yes. (See page 62)
C To reset each menu mode, touch the CANCEL button on the touch panel.
Edge # When the vertical and horizontal void areas are the
same, adjust the void width by using the F·G buttons,
then touch the OK button.
# When the vertical and horizontal void areas are
different, select vertical or horizontal edge.
$ Adjust each void width by using the F·G buttons.
% Touch the OK button.
∗
Initial setting (Factory setting): 5 mm
# Adjust void width by using the F·G buttons.
$ Touch the OK button.
∗
Initial setting (Factory setting): 20 mm
# Select the Margin area.
$ Adjust void width by using the F·G buttons.
The image is moved only by the void width which has
been set.
**
% Touch the OK button.
∗
Initial setting (Factory setting): 10 mm
Book
Margin
5
Press
START
1
Place the
Original(s)
2
Select ZOOM/
EFFECT Mode
3
Select Edge, Book or
Margin
4
Number
of Copies
Making Copies
P040-041_4510(pb).p65 7/31/02, 10:44 AM 41