Printek FORMSMASTER 8000SE - Manual (Page 38)

D A I L Y O P E R A T I O N
30
8. Place the left edge of the new form in the left tractor with the holes
aligned with tractor pins. Make sure that the top edge of the form
does not extend above the top of the tractors.
Paper positioned in left tractor.
9. Close the left tractor door.
10. Now position the paper in the right tractor in the same fashion. If
necessary, the position of the right tractor may be adjusted. To do
so, move the lever on the side of the tractor down to unlock the
tractor and slide the tractor sideways on the shafts. If necessary, the
paper guides between the tractors may be slid in either direction to
accommodate the form width. Make sure that the guides are spaced
evenly between the tractors.
After the paper is placed in the tractor and the door is closed,
position the tractor far enough to the right so that there is no buckle in
the paper between the tractors, but not so tight that the holes in the
paper are distorted. Lock the tractor in place by returning the lever
to the up position.