Printek FORMSMASTER 8000SE - Manual (Page 50)

P R I N T E R C O N F I G U R A T I O N
42
the line, use the right buttons. Note also that the menu system works on a
“what you see is what you get” basis. This means that whatever value is last
displayed for an item is the value that will be saved when Setup mode is
exited.
Entering Setup
To enter Setup, simply take the printer off line and press the SETUP button.
The ONLINE indicator will begin to flash yellow and the display will
temporarily show the following.
Entering
Setup Menus
After the above message has been shown, the display will change to the first
menu available, which is the FORMS MENU as shown below. In this case
the display will also show the first submenu which will be the form that was
selected when Setup was pressed.
FORMS MENU
Form 0
Using the MENU Button
At this time you may select a different menu by pressing the MENU button
(closest to where FORMS MENU is displayed). Other menus available are
the INTERFACE MENU, the OPTIONS MENU, and the TEST
MENU. This button will also display an option for exiting Setup. If you do
not wish to exit Setup at this time, press the button indicated for No and
continue to press the MENU button to select the desired menu. The MENU
button may be pressed at any time to select a different menu.
Using the SUBMENU Button
The SUBMENU button selects additional menus that are related to the
selected menu. For instance, if the FORMS MENU has been selected, the
SUBMENU button (closest to where the form number is displayed) will