Printek FORMSMASTER 8000SE - Manual (Page 74)

P R I N T E R C O N F I G U R A T I O N
66
This item sets the Imager or ImagerPlus emulation mode. QMS CodeV
v2 selects QMS Code V version 2, PTX CodeV v2 selects Printronix
Code V version 2.
Control Character ControlCharact
er
^ (5E Hex)
Possible Values: ^ (5E Hex)*
SOH (01 Hex) through HT (09 Hex),
SO (0E Hex) through (FF Hex)
This item sets the control character used to begin commands. The
character normally used for QMS is the caret (^) and the character nomally
used for IGP is the tilde (~) (if you change the emulation to Printronix
IGP, you may need to change the control character to the tilde).
Line Terminator Line
Terminator
LF
Possible Values: LF*, CR
This item sets the line terminating character to a Line Feed or a Carriage
Return.
Bar Code Density Bar Code
Density
High-Res
Possible Values: Low-Res, Medium-Res, High-Res*,
Graphics Med-Res
This item sets the density, or graphics resolution, for bar codes.
QMS Character Set
(QMS CodeV v2 and PTX CodeV v2 only) QMS Char Set
USA