Printek FORMSMASTER 8000SE - Manual (Page 43)

D A I L Y O P E R A T I O N
35
2. Grasp the left end of the ribbon cartridge and lift it up and toward the
rear of the printer as shown below.
Removing the Old Ribbon Cartridge
3. Lift the right end of the ribbon and remove the ribbon from the
printer.
Installing the New Ribbon Cartridge.
Note: The use of Printek brand ribbons is recommended for increased
ribbon life and print head life. The use of only Printek brand
ribbons is required for the extended print head warranty. For
details, see “
Why Use Only Printek Brand Ribbons ” in the
“ GETTING STARTED ” chapter.
4. Remove the new ribbon from its plastic bag and make sure the
ribbon fabric is taut by turning the knob on top of the ribbon
cartridge in a counterclockwise direction as indicated by the arrow
on the cartridge.
5. Install the new ribbon by reversing the above removal process. For
a more detailed installation description, see “ Installing the Ribbon
Cartridge ” on page 10.
6. Close the ribbon lid and place printer back on line.