Printronix P5000LJ Series - Manual (Page 131)

Auto Switching Submenu
131
• Paperout Adj. It is recommended that only a Hewlett-Packard Customer
Service Engineer run this test.
The Paperout Adj. allows the Customer Service Engineer to specify
where the last line of text will print when there is a paper out condition.
Setting this parameter correctly prevents printing on the platen. (See the
P5000LJ Series Printers Maintenance Manual for more information.)
• Burnin Test. Running this test is not recommended.
• Print Error Log. Prints a log of the last 50 errors that have occurred in
the printer.
• Clear Error Log. Clears the error log.
• E-Net Test Page. Prints the Ethernet statistics stored on the Ethernet
adapter (if present).
Test Width
This parameter permits you to run the self-tests at full width or 80 columns.
Paper Out Dots
It is recommended that only an authorized Printronix representative sets this
parameter.
Paper Out Dots allows the Customer Service Engineer to specify where the
last line on the page will print when there is a paper out condition. Setting this
parameter correctly prevents printing on the platen.
System Memory
This parameter displays the amount of RAM installed.
Note The printer must be printing the phase pattern of “H’s” when the Phasing
Value is changed or the new phasing value will not be written into non-
volatile RAM (NVRAM). If the value is changed when not printing, the
printer will return to its default phasing value when powered off and then
back on.
Caution This parameter must match paper width used. If full width is selected
for use with 80-column or 8.5-inch wide paper, damage to the
hammer tips and platen may result.