Printronix P5000LJ Series - Manual (Page 248)

248
Chapter 13 Complete Command List
Set the destination to handle only certain print services. To add a
service, specify the service name. To disable a service, use “ - ” before the
name. The available services are:
socket Direct socket printing via TCP/IP.
lpd LPR printing with TCP/IP including LPR clients on any
platform.
lpsched LP or System V printing with TCP/IP.
rprinter Novell RPRINTER support.
pserver Novell PSERVER support.
netbios Windows 95 and Windows for Workgroups printing.
ftpd Printing using the File Transfer Protocol (ftp) via TCP/IP.
set dest from default
Set all destination settings back to factory defaults.
set dest from stored
Set all current destination settings to the values stored in flash memory.
set logpath logpath name newname
set logpath l1 name pagecount
Change the current name of the logpath to a new name as indicated by
newname . This newname must be nine characters or less or it will be
truncated. These names are case sensitive.
set logpath logpath type [[-]job] [[-]user] [[-]pgcnt]
[[-]cksum] [[-]printer] [[-]ioport]
set logpath l2 type job user printer pgcnt
Establish the type of printer and print job logging to be done within this
logpath . The options are:
job Job ID, username, etc.
user User ID along with three messages per job about start and
finish.
pgcnt For total pages printed in a job.
cksum 16-bit checksum value to confirm integrity of data printed.
printer For special printer feedback.
ioport Printer error messages determined through the parallel port
pins.