Printronix P5000LJ Series - Manual (Page 246)

246
Chapter 13 Complete Command List
Store the IP address for the NIC.
store tcpip ifnum mask netmask
store tcpip 1 mask 255.255.255.0
Store the subnet mask for the NIC.
store tcpip ifnum opts [[-]rarp] [[-]bootp] [[-]dhcp]
store tcpip 1 opts -rarp -bootp -dhcp
Enable or disable the automatic RARP, BOOTP, or DHCP requests for IP
addresses upon bootup. If you are storing the NIC TCP/IP network
settings within the device, you will not need to rely on RARP, BOOTP, or
DHCP for new settings.
store tcpip ifnum frametype [[-]ethernet2]
[[-]802.2snap]
store tcpip 1 frametype ethernet2 802.2snap
Control which frame type(s) is supported with the TCP/IP protocol. By
default, both
ethernet2 and 802.2snap are enabled but normal
TCP/IP communications rely on Ethernet 2. This setting has no affect on
other supported network protocols (e.g., Novell).
store tcpip route add|del host|net IPaddress ifnum
store tcpip route add net 192.75.12.0 1
store tcpip route del net 192.75.12.9 1
Add or delete a static route to a particular TCP/IP host or subnet specified
by
IPaddress so the NIC knows how to communicate with it. Normally
one entry for a default router/gateway is all that is needed for
communications between different subnets. Please see the next
command for details.
store tcpip route add|del default routerIPaddress
ifnum
store tcpip route add default 192.75.11.1 1
Store a default router/gateway defined by routerIPaddress so the NIC
knows where to direct packets destined for another subnet. It is easier to
store one default entry rather than an entry per remote host or network as
in the previous command.
store tcpip tcp rxwin packets
store tcpip tcp rxwin 2
Determine the receive window size for the NIC. Usually the packets
value ranges from 2 to 8 with the lower number allowing for more
simultaneous TCP connections with the print server.
store tcpip tcp opts [-]keepalive [-]disbufmgmt
store tcpip tcp opts keepalive -disbufmgmt
Control whether the NIC maintains a connection with a host when data
cannot be accepted into its buffer. Normally the
keepalive feature is
enabled so when the printer can not accept data, the print job connection
is maintained and continued once the situation clears. If
disbufmgmt is
disabled (i.e., “-”), the NIC will not buffer any data when there is a blocked
situation with the printer. Normally it is best to have both
keepalive and
disbufmgmt enabled.
store tcpip tcp access [root] add|del IPaddress