Printronix P5000LJ Series - Manual (Page 129)

Auto Switching Submenu
129
Power Saver Time
Power Saver is also referred to as the E NERGY S TAR
®
Office Equipment
Program. The Power Saver feature places the printer in “sleep mode” when
the printer has not been used for a specified number of minutes. In sleep
mode the printer is in low-energy idle state, all fans and higher voltages are
off, and only +5Vdc logical circuits are active.
You can designate the number of minutes after which the printer will go into
sleep mode. The range of time is from 0 to 60 minutes. The default is 15
minutes.
Pressing any key on the control panel or sending a print job to the printer will
turn off sleep mode.
Diagnostics Menu
The diagnostics menu allows you to choose the diagnostics tests to be run
and provides you with important system information. Options on this menu, as
shown below, are described in the following pages.
DIAGNOSTICS
Printer Tests Test Width Paper Out
Dots
System
Memory
Print Statistics
Shift Recycle*
All E’s
E’s + TOF
All H’s
All Underlines
All Black
Shuttle Slow
Shuttle Fast
Shuttle Only
Phase Printer
217* (500 lpm)
123* (1000 lpm)
62* (1500 lpm)
(1 to 2000)
Paperout Adj.
Burnin Test
Print Error Log
Clear Error Log
E-Net Test Page
1
Full Width*
80 columns 40 dots*
(4-76 dots) x Megabytes On: x.x Hrs.
Print: x.x Hrs.
Print Strokes
Print Lines
11 inch Pages
1 If Ethernet adapter is present