Printronix P5000LJ Series - Manual (Page 254)

254
Chapter 13 Complete Command List
List Commands
These commands list the current or working settings for a particular section
within the command shell. To view stored settings in flash memory, you will
need to add in
stored within the beginning of any of the following
commands. For example, list prn shows you the current prn settings but
list stored prn shows you the settings sitting in flash memory.
Normally these should match.
list arp
List the current ARP table that the NIC adheres to in a TCP/IP network.
list date
List the current date on the NIC.
list dest
List the current destination settings (e.g., names and mapped I/O ports,
models, and logpaths).
list diff
List the differences between the current settings and the stored settings in
flash memory. Normally, you want these values to match, so issue a
save command followed by a reset .
list ifc
List the current UTP interface settings (e.g., link integrity).
list key
List the license details and license key number.
list logins
List any active user logins on the NIC.
list logpath
List the current logpath settings (e.g., names and mapped destinations).
list model
List the current model settings (e.g., names and mapped destinations).
list pserver
List the current general print server settings (e.g., print server name and
Novell mode).
list prn
List the current parallel port setting (e.g., mode).
list rprinter
List any current RPRINTER definitions.
list snmp
List Trap Table containing SNMP Managers.
list sysinfo
List the current NIC system information (e.g., contact name and protocol
stacks enabled).
list tcpip
List all current TCP/IP network settings (e.g., IP address and subnet
mask).