NEC 4650N - Manual (Page 89)

Scanner Copy Feature 83
ADVANCED FEATURES
S CANNER C OPY F EATURE
The printer works with the HP ScanJet ® 6300C and Astra ®
1200S, 1220S, or 2400S scanner.
Setting Up the Scanner
Before you can print, you must set up the printer to work
with the scanner. If you have an HP 6300 you will need to
have the proper SCSI cable*.
1. Make sure the scanner is not plugged into the power and
the printer is turned OFF.
2. Plug the SCSI cable from the scanner to the SCSI port on
the Interface Panel of the printer (A).
note: The SCSI scanner cable can also be plugged into
the Zip drive SCSI port if a Zip drive is already connected
to the printer. Set the Zip drive terminator to OFF when
attaching the scanner (B).
3. Attach the SCSI terminator provided with the scanner to
the SCSI port of the scanner. Refer to the scanner’s
documentation on how to attach the terminator.
4. If you have an Astra scanner, locate the SCSI ID switch
on the back of the scanner.
If you have an HP scanner go to Step 6. The SCSI ID
switch will set automatically.
5. With a small screw driver gently turn the SCSI ID switch
to 4, the usual factory default is 5 (C).
6. Turn the scanner, Zip drive if present, and then printer
ON.
Caution! Do not plug in the scanner while the printer
is turned ON.
*SCSI-2 cable with a HD 50-pin male connector and a DB 25-
pin male connector.
A B
C