NEC NHD-3000PVR - Manual (Page 17)

Connect the HDMI Cable
15
Connection to Digital TV (HDMI/DVI) 05
Installation
Connect the HDMI/DVI output jack of the STB to the HDMI input jack of the digital TV. In regard to the
Video Out Mode, select one of 1080i, 720p, 576p as Video Resolution according to your digital TV.
NOTE
By pressing the remote, V-OUTPUT (2 buttons), you will be able to change the output ‘YPbPr’ and
‘RGB’. (YPbPr selection is usually used for Component Input, while RGB selection is usually used for
PC/HDMI Input)
By pressing the remote, V-FORMAT (2 buttons), you will be able to change the format ‘1080i’,
‘720p’, ‘576p’, ‘576i’.
When you connect using HDMI, depending on your digital TV, you can change the value of video
timing by going to the HDMI VIDEO selection at the MENU. The two selections available are :
HDMI means the value of video timing is setup for HDMI
YPbPr/RGB means the value of video timing is setup for YPbPr/RGB
You can view the difference between the two selections above by pressing ‘MARK’. If you see
OUTPUT, and there is a letter ‘H’ in the beginning (eg: OUTPUT: H1080), it means HDMI is selected.
If you see OUTPUT, (eg: OUTPUT: 1080), it means normal YPbPr/RGB is selected.
< Digital TV >