National Instruments Graphical User Interface Ultiboard User Manual
Page 152
Chapter 5
Working with Traces and Copper
5-8
ni.com
4.
Optionally, click on one of the following checkboxes in the Advanced
options area and then click the Options button when it becomes
active:
•
Net Group—Displays the Select Groups dialog box where you
select the net groups to which you wish to apply the Keep-in/out.
•
Part Height—Displays the Part Height Ranges dialog box
where you enter the height of parts to which you wish the
Keep-in/out area to apply.
•
Part Group—Displays the Select Groups dialog box where you
select the part groups to which you wish to apply the Keep-in/out
area.
5.
Click OK in the Keep-in/Keep-out Properties dialog box.
If no Advanced options are set:
•
A DRC error is reported if an object is moved outside of a Keep-in
area.
•
A DRC error is reported if an object is inside a Keep-out area.
•
If there are multipleKeep-ins or Keep-outs, the objects may be divided
amongst the different areas at your discretion. Multiple areas then
behave as a single disjointed area.
If any Advanced options are set:
•
A DRC error is reported if an object is moved outside of a Keep-in
area.
•
A DRC error is reported if an object is inside a Keep-out area.