National Instruments Graphical User Interface Ultiboard - Manual (Page 52)

Chapter 1 User Interface
NI Ultiboard User Manual 1-36 ni.com
Min Width The minimum width to which a trace will be laid
during routing. You can enter a value here, or use the
Group Editor. Refer to the
Working with the Group
Editor of Chapter 3, Setting Up a Design , section for
more information.
Topology The topology of the net as set in the Netlist Editor.
Choices are Shortest, Daisy Chain and Star. Refer to
the
Using the Netlist Editor section of Chapter 5,
Working with Traces and Copper , for more
information. This feature is not available in all
versions of Ultiboard.
Trace Length Length of the routed net.
Max Length Maximum allowable length of copper in a net. Not
applicable (N/A) if Topology is set to Shortest.
Min Length MInimum allowable length of copper in a net. Not
applicable (N/A) if Topology is set to Shortest.
Trace
Clearance This is the minimum spacing allowed between the
parts in the group and any trace. You can enter a value
here, or use the Group Editor. Refer to the
Working
with the Group Editor section of Chapter 3, Setting
Up a Design , for more information.
Routing
Layers The routing layers assigned to this net group. Click to
display the Layers to Apply dialog box, where you
set the layers to use for routing copper.
Routing
Priority The routing priority for the selected net. 1 is the
highest priority, 2 the second highest, etc. Leave as
None if priority routing is not required. This feature is
not available in all versions of Ultiboard.
Net Group This is the group in which the net is contained. You
can either enter the group name here, or use the
Group Editor. Refer to the
Working with the Group
Editor section of Chapter 3, Setting Up a Design , for
more information.
Column Description