National Instruments Graphical User Interface Ultiboard - Manual (Page 249)

Appendix A Menus and Commands
NI Ultiboard User Manual A-8 ni.com
View Menu
The subjects in this section describe the commands found in the View
menu.
View»Full Screen
Use to fill the screen with the design only (hide menus, toolbars, other
windows). Click the Close Full Screen button to return to normal view.
View»Redraw Screen
Use to refresh the screen.
View»Zoom In
Use to zoom in to see more details.
View»Zoom Out
Use to zoom out to see more of the design.
View»Zoom Window
Use to magnify a selected part of the board. Use this command when you
want precise control over the workspace view.
View»Zoom Full
Use to return to the full view of the design after zooming in or out. Ctrl-F7
zooms out so that the entire design is visible and centered. This includes the
board outline and any objects that may be either inside or outside the board.
F7 zooms out so that the board is visible and centered. Any objects outside
the board outline will be outside the visible region.
View»Clearances
Use to toggle the clearances around pads, traces and other objects on and
off. Refer to the
Placing Traces section of Chapter 5, Working with Traces
and Copper , for more information.
View»Grid
Use to toggle the visual grid on and off.