National Instruments Graphical User Interface Ultiboard - Manual (Page 259)

Appendix A Menus and Commands
NI Ultiboard User Manual A-18 ni.com
Tools»Database»Convert Database
Use to update your old User and Corporate databases to Ultiboard 10
format. Refer to the
Converting Databases section of Chapter 4, Working
with Parts , for more information.
Tools»PCB Transmission Line Calculator
Use to calculate parameters for typical printed circuit board trace
geometries. Refer to the
PCB Transmission Line Calculator section of
Chapter 6, PCB Calculators , for more information.
Tools»PCB Differential Impedance Calculator
Use to perform calculations for two traces that carry signals that are exactly
equal and opposite (a differential pair). Refer to the
PCB Differential
Impedance Calculator section of Chapter 6, PCB Calculators , for more
information.
Tools»Netlist Editor
Use to remove or add nets and pads. Refer to the Using the Netlist Editor
section of Chapter 5, Working with Traces and Copper , for more
information.
Tools»Group Editor
Use to set up and edit various group types. Refer to the Working with the
Group Editor section of Chapter 3, Setting Up a Design , for more
information.
Tools»Quick Layer Toggle
Use to toggle between the last copper layer or to the opposite copper layer
if the last layer was not copper.
Tools»Renumber Parts
Use to renumber parts in preparation for production. Refer to the
Renumbering Parts section of Chapter 8, Preparing for
Manufacturing/Assembly , for more information.