National Instruments Graphical User Interface Ultiboard - Manual (Page 57)

Chapter 1 User Interface
© National Instruments Corporation 1-41 NI Ultiboard User Manual
Inner Pad
Shape The shape of the inner layer pad as set in the Through
Hole Pin Properties dialog box. Refer to the
Viewing
and Editing Through Hole Pin Properties section of
Chapter 4, Working with Parts , for more information.
Bottom Pad
Shape The shape of the bottom layer pad as set in the
Through Hole Pin Properties dialog box. Refer to
the
Viewing and Editing Through Hole Pin Properties
section of Chapter 4, Working with Parts , for more
information.
Annular Ring The size of the annular ring for this pad as set in the
Through Hole Pin Properties dialog box. Refer to
the
Viewing and Editing Through Hole Pin Properties
section of Chapter 4, Working with Parts , for more
information.
Pad Diameter The diameter of the pad as set in the Through Hole
Pin Properties dialog box. Refer to the
Viewing and
Editing Through Hole Pin Properties section of
Chapter 4, Working with Parts , for more information.
Drill
Diameter The diameter of the drill hole in the pad, as set in the
Through Hole Pin Properties dialog box. Refer to
the
Viewing and Editing Through Hole Pin Properties
section of Chapter 4, Working with Parts , for more
information.
Trace
Clearance The minimum clearance permitted between the pad
and traces, as set in the Through Hole Pin Properties
dialog box. Refer to the
Viewing and Editing Through
Hole Pin Properties section of Chapter 4, Working
with Parts , for more information.
Column Description