National Instruments Graphical User Interface Ultiboard - Manual (Page 246)

Appendix A Menus and Commands
© National Instruments Corporation A-5 NI Ultiboard User Manual
• Open Trace Ends—Use to delete all open trace ends in the design.
Use to clean up the design after design completion. Refer to the
Deleting Open Trace Ends section of Chapter 8, Preparing for
Manufacturing/Assembly , for more information.
• Copper Island—Use to remove copper islands. Refer to the Placing
Copper Areas section of Chapter 5, Working with Traces and Copper ,
for more information.
Edit»Find
Use to find an element in the design. Refer to the Searching for Design
Elements section of Chapter 2, Beginning a Design , for more information.
Edit»Select All
Use to select everything on a board, no matter what layer the elements are
on. Refer to the
Searching for Design Elements section of Chapter 2,
Beginning a Design , for more information.
Edit»Select Entire Trace
Use to select a whole trace when one or more segments of the same trace
are selected.
Edit»Group Selection
Groups selected elements together. Grouped elements can be moved
together.
Edit»Ungroup Selection
Ungroups the individual elements in a group.
Edit»Lock
Locks the selected elements in place so they cannot be moved.
Edit»Unlock
Unlocks the selected elements.