Radio Shack PRO-2051 - Manual (Page 11)

11
The Basics
step 1: install your scanner
mounting the scanner in your vehicle
Before you mount the scanner, make sure you have all the
necessary materials. Then confi rm your vehicle has enough
room to mount: 2.44” high by 7.06”wide by 6.10” deep
(50.8 x 176.5 x 152 mm).
Be sure to avoid obstructions behind the mounting
surface.
Follow these steps to mount the scanner in your vehicle.
To mount your scanner on top of the dashboard, rotate the
bracket so the ears point up. To use on a fl at surface, fl ip
down the built-in stand underneath the scanner.
1. Choose a mounting location, then use the supplied
mounting bracket as a template to mark the positions for
the mounting holes.
2. In the marked positions, drill holes slightly smaller than
the supplied screws.
3. Attach the mounting bracket to the mounting location
using the supplied screws and lock washers.
4. Attach the scanner to the mounting bracket using the
supplied mounting knobs.
slide scanner into
bracket
Note Note