Radio Shack PRO-2051 - Manual (Page 54)

54
Beyond the Basics
programming scan lists during search
To select a scan list location and store an ID during search
mode, follow these steps:
1. When your scanner stops on an ID you want to store,
press HOLD/RESUME.
2. You can change the scan list memory location by using
the e or d key. Then press E.
3. Press SRCH to return to trunk tracking search mode.
deleting a stored ID
1. Press HOLD/RESUME in the ID scan mode.
2. Select the scan list location you want to delete by using
the e or d key.
3. Press 0.
4. Then press E.
direct entry ID hold mode
In hold mode (ID scan hold or search hold), enter the ID you
want to receive by using 1 through 9, 0 (or ./CLR) and press
d , and you can listen to a specifi c ID (without storing that ID
to a list).
ID monitor mode
If you press and hold SRCH for 2 seconds, until you hear
two short beeps, you will select the ID monitor mode. SRCH
begins fl ashing and all active talk group IDs appear. When
you monitor IDs, any IDs you have locked out also appear.
You will not hear conversations in this mode, but this is an
excellent way to determine which talk groups are the most