Radio Shack PRO-2051 - Manual (Page 49)

49
Beyond the Basics
3. Then, press E. E (EDACS), M (Motorola) or L (LTR)
appears depending on the trunked system selected. If
the frequency is out of the range of the system chosen in
this step, you will hear an error tone, the channel number
fl ashes and an error message appears on the display.
4. Use the e or d key to select the next channel in the bank.
5. Repeat Steps 2 through 4 until all frequencies have been
entered.
6. Press SRCH to begin searching the bank you’ve
programmed.
Then select the programmed bank by using the keypad.
To lock out the keypad to prevent reprogramming of talk
groups, you can use memory lock (Refer to “Memory
Lock”).
If you want to return to the previous menu screen, press
HOLD/RESUME in the trunk programming mode.
programming id scan lists manually
When you designate a bank as a trunking bank, your scanner
sets up 10 scan lists, which are simply lists used to store your
favorite talk group IDs. Each list can contain up to 10 IDs, so
you can store a total of 100 IDs for each trunking bank. If you
use all the banks for trunking, 1,000 IDs will be available.
Once IDs are stored in lists, you can scan them like you scan
conventional frequencies.
1. Select the trunking programming mode and the bank you
want to change.
2. Use e or d to choose trunk system, and press E.
3. Use e or d to choose Prog ID, and press E.
Notes Notes