Radio Shack PRO-2051 - Manual (Page 78)

78
Beyond the Basics
resetting your scanner
If the scanner’s display locks up or stops operating properly,
you might need to reset the scanner.
This procedure clears all the information you have stored
in the scanner. Before you reset the scanner, try turning
it off and on to see if it begins working properly. Reset
the scanner only when you are sure it is not working
properly.
1. Make sure your scanner is turned off.
2. While holding down 2, 9, and HOLD, turn on the scanner.
After about 2 seconds the scanner initializes and CLEAr
appears.
Follow these steps to restore the 150 preprogrammed
frequencies stored in the private bank.
1. Make sure your scanner is turned off.
2. While holding down 3 and E, turn on the scanner. After
several seconds, the scanner restores the frequencies.
Note Note