Radio Shack PRO-2051 - Manual (Page 34)

34
Beyond the Basics
scanning highway patrol, local police,
and private frequencies
If the scanner is set to any mode other than the highway
patrol, local police, or private mode, press PVT and then
press STATE to display only HIGHWAY. Once HIGHWAY
appears on the display, use the table below.
Press these buttons Action
FUNC + HWY/POL (1x) Scan highway patrol and local police
FUNC + HWY/POL (2x) Scan only local police
FUNC + HWY/POL (3x) Scan only highway patrol
To scan highway patrol, local police and private frequencies,
press PVT. Once both HIGHWAY and PRIVATE appear on the
display, use the table below.
Press these buttons Action
FUNC + HWY/POL (1x) Scan highway patrol, local police and
private frequencies
FUNC + HWY/POL (2x) Scan local police and private
frequencies
FUNC + HWY/POL (3x) Scan only private frequencies
FUNC + HWY/POL (4x) Scan highway patrol and private
frequencies
If your scanner is in a mode other than highway patrol, local
police, or private, press PVT. The previously selected bank or
banks appear. When the scanner receives a signal, scanning
stops and the state code and frequency appear. When the
transmission ends, the scanner holds for 2 seconds on that
frequency for a response. For more information about the
delay feature, see “Delay”. If there is no response, scanning
resumes.