Radio Shack PRO-2051 - Manual (Page 12)

12
The Basics
step 2: power your scanner
from a wall outlet
1. Connect the tip of the supplied AC adapter to the DC 12V
jack at the rear of your scanner.
2. Plug the AC adapter into your wall outlet.
You must use a Class 2 power source that supplies 12V
DC and delivers at least 500mA. Its center tip must be set
to positive and its plug must fi t the scanner’s DC 12V jack.
Using an adapter that does not meet these specifi cations
could damage the scanner or the adapter.
To prevent electric shock, do not use the AC adapter’s
polarized plug with an extension cord, receptacle, or
other outlet unless you can fully insert the blades to
prevent blade exposure.
through your vehicle’s ignition (negative
ground only)
If you are not experienced in connecting accessories to
the vehicle fuse box, use a certifi ed installer.
1. Disconnect the cable from the negative (-) terminal of
your vehicle’s battery.
2. Ground the black wire of the
supplied DC power cord to
your vehicle’s chassis.
Rear View
Note Note
Notes Notes