Raymarine ST60 Tridata - Manual (Page 30)

18 ST60 Tridata Instrument Owner’s Manual
3.2 Procedures
As it is not possible to describe procedures for all possible installation
scenarios, the procedures given here describe the broad requirements for
installing the Speed and Depth transducers and the ST60 Tridata
instrument. Adapt these procedures as appropriate, to suit your
individual requirement.
CAUTION:
Where it is necessary to cut holes (e.g. for cable routing and
instrument mounting), ensure that these will not cause a hazard by
weakening critical parts of the vessel’s structure.
Unpacking
Unpack your ST60 equipment and check that the items described in
Introduction are present.
Each ST60 instrument is supplied with a standard bezel for surface
mounting. Optional mounting kits are available for flush mounting and
bracket mounting the instrument. If you have ordered the flush mounting
option a low-profile bezel and four fixing screws are also provided.
Fitting the instrument
The ST60 Tridata instrument can be installed using one of a number of
different mounting options:
• Surface mounting. Gives a profile of approximately 24 mm.
• Flush mounting. Gives a profile of approximately 6 mm.
• Bracket mounting.
The ST60 instruments can also be mounted behind a panel with just the
instrument dial and keys visible.
Surface mounting
To surface mount your ST60 instrument (see the Surface mounting
illustration):
1. Ensure that:
• The selected location is clean, smooth and flat.
• There is sufficient space behind the selected location to accom-
modate the rear of the instrument and connectors.
81040_1.book Page 18 Thursday, November 7, 2002 10:21 AM