Ricoh 170 / 180 - Manual (Page 99)

REPORT FORMATS
Example 1. Error Report
The following report means that the machine sent four pages but there were
errors during the first two pages.
*** Error Report (Aug 24 1995 12:09PM) ***
TTI XYZ COMPANY
FILE ADDRESS MODE TIME PAGE RESULT
0087 XYZ CO. NEW YORK TES 0’29" P.4 E
PAGE NOT SENT
P. 1
Example 2. TCR
*** TCR (Aug 24 1994 11:40AM) ***
TTI XYZ COMPANY
<TX>
DATE TIME ADDRESS MODE TIME PAGE RESULT FILE
--------------------------------------------------------------------
APR 28 9:48AM XYZ NEW YORK TES 1’11" P. 5 OK 005
9:54AM XYZ LONDON TES 0’27" P. 1 OK 007
9:56AM 2125551234 TES 0’28" P. 1 OK 009
10:01AM XYZ BERLIN TES 0’24" P. 1 OK 010
<RX>
DATE TIME ADDRESS MODE TIME PAGE RESULT FILE
-------------------------------------------------------------------
APR 28 9:51AM DR J ALVAREZ RS 0’24" P. 1 OK 006
9:58AM 2015551234 RES 0"27" P. 1 OK 008
10:56AM XYZ PARIS RES 0’28" P. 1 OK 011
11:01AM M. JONES RES 0"24" P. 1 OK 012
In the Result column, some reports may have an "E" followed by a code, and
there may be a message printed at the bottom of the report. This code and there
may be a message printed at the bottom a problem occurred. The code are
explained below.
Result Message Explanation
1
Hang up or line
fail The other party either hung up or had no message
on polling standby. Alternatively, there could have
been a problem with the line.
2 Busy The machine at the other end was busy.
3 No answer The line is dead (no dial tone was detected).
4 No connection There is no facsimile machine at the other end.
88