Ricoh CAPLIO G4 WIDE - Manual (Page 118)

Chapter 1 Section 6 Changing Camera Settings
118
ON (Continue numbering)
File names will be automatically assigned to still
images you take, in the format of "R" followed by 7 dig-
its, from R0010001.jpg to R9999999.jpg.
With this setting, even when one SD Memory Card is
switched with another, consecutive file numbering from
the previous card is continued.
OFF (Do not continue numbering) (Default)
Every time a new card is loaded, file numbering is
assigned, from RIMG0001.jpg to RIMG9999.jpg.
If numbering exceeds RIMG9999, further recording is
not possible.
To make changes to file numbering, follow
the steps below.
Turn the Mode Dial to 1 1 1 1 (Setup Mode).
The Setup Screen appears.
Press the " " " " button to select [SEQUEN-
TIAL NO.].
Press the #$ #$ #$ #$ buttons to select the
desired setting.
This setting will be used for shooting until you change
it.
When you are recording to internal memory, file names are assigned just as when [SEQUENTIAL NO.] is set to [OFF].
Extension
The characters "jpg" following the period in a file name are called the extension and indicate file's type. A type of "jpg" indicates that the
file is in JPEG format. The extension is always separated from the file name by a period.
JPEG Files
This is read "Jay-Peg" file. This is one of the file formats used for saving image data. It is widely used when recording still images, its
strong point being its small file size.
Changing File Name Settings (SEQUENTIAL NO.)
When you shoot a still image, it is stored on an SD Memory Card or in internal memory, with a consecu-
tively numbered file name automatically assigned.
When you are switching SD Memory Cards, you can set your camera to continue consecutive number-
ing from the previously loaded SD Memory Card.