G. troubleshooting, Power supply, Shooting – Ricoh CAPLIO G4 WIDE User Manual
Page 177
Appendices
177
G. Troubleshooting
Refer to the symptoms and measures listed below before sending the camera for repairs. If the problem
persists, contact your nearest Ricoh Service Center.
Power Supply
Symptom
Cause
Measure
Page
The power does not
come on.
Batteries are not loaded. Or they are exhausted.
Load the batteries correctly. Recharge or use the AC
Adapter.
The AC Adapter is not connected correctly.
Reconnect it properly.
Because the camera overheated the power was auto-
matically turned off.
Wait until the temperature of the camera returns to
normal. Do not attempt to cool the camera suddenly.
-
The power cuts out
during use.
The camera was left unattended and unused, so Auto
Power-Off shut it off.
Turn the power back on.
Batteries are running low.
If you are using alkaline batteries, replace them. If you
are using a rechargeable battery, recharge it or use
the AC Adapter.
The power does not
go off.
Camera malfunction.
Reload batteries.
If using the AC Adapter, reconnect it.
Cannot recharge the
batteries.
Battery life.
Replace the batteries with a new set.
Batteries run out
quickly.
They are being used in extreme high or low tempera-
tures.
-
-
Many shots are being taken in dark places inside,
requiring flash.
-
-
Shooting
Symptom
Cause
Measure
Page
Even if I press the but-
ton, the camera does
not shoot.
Batteries are not loaded. Or they are exhausted.
If using alkaline batteries, replace the batteries with a
new set. If using rechargeable batteries, recharge or
use the AC Adapter.
The power is not on. Or the camera is not in Shooting
Mode.
Turn the power on and turn the Mode Dial to Shooting
Mode.
The shutter button is not pressed all the way.
Press the shutter button all the way.
The Memory Card is not formatted.
Format the card.
The Memory Card does not have any free space.
Load a new card, or delete unwanted files.
End of Memory Card life.
Load a new Memory Card.
The flash is recharging.
Wait until the flash lamp stops blinking.
The SD Memory Card is "locked".
Release the "Lock (write-protection)".
The SD Memory Card's contact surfaces are dirty.
Wipe off with a soft, dry cloth.
-
I cannot check shot
images.
The image confirmation time is too short.
Lengthen the image confirmation time.