Ricoh CAPLIO R4 - Manual (Page 121)

119
Chan
gi
ng Cam
era
S
e
ttings
Changing Image Confirmation Time
(LCD CONFIRM.)
Immediately after you press the shutter release button, the still
image taken is displayed on the screen for a moment so you can
check it.
By default, the image confirmation time is set to 0.5 seconds, but this
can be changed.
To change the image confirmation time, follow the steps below.
1.
Display the SETUP menu.
For the operating procedure, see P.111.
2.
Press the " button to select [LCD CONFIRM.] and press the
$ button.
3.
Press the !" buttons to select
the desired setting.
4.
Press the C/D or # button.
5.
If you pressed the # button in
Step 4, press also the C/D
button.
This setting is used until it is changed.
Caution
When [LCD CONFIRM.] is set to 0.5 seconds, symbols such as the zoom bar may remain on
the monitor while the image is displayed.
Available Settings
OFF (Image not displayed for confirmation)
0.5SEC. *Default setting
1 SEC.
2 SEC.
3 SEC.