Roberts Gorden Compact Tubular Unit Heaters CTCU 27 - Manual (Page 8)

COMBAT ® CTCU U NIT H EATERS I NSTALLATION O PERATION AND S ERVICE M ANUAL
2 of 42
SECTION 1: HEATER SAFETY
Your Safety is Important to Us!
This symbol is used throughout the
manual to notify you of possible fire,
electrical or burn hazards. Please pay
special attention when reading and
following the warnings in these sections.
Installation, service and annual inspection of heater
must be done by a registered installer/contractor
qualified in the installation and service of gas-fired
heating equipment.
Read this manual carefully before installation,
operation, or service of this equipment.
This heater is designed for heating non-residential
indoor spaces. Do not install in residential spaces.
These instructions, the layout drawing, local codes
and ordinances, and applicable standards that apply
to gas piping, electrical wiring, venting, etc. must be
thoroughly understood before proceeding with the
installation.
Protective gear is to be worn during installation,
operation and service. Thin sheet metal parts have
sharp edges. To prevent injury, the use of work
gloves is recommended. The use of gloves will also
prevent the transfer of body oils from the hands.
Before installation, check that the local distribution
conditions, nature of gas and pressure, and
adjustment of the appliance are compatible.
The heater must be applied and operated under the
general concepts of reasonable use.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do no play with the appliance.
For additional copies of the Installation, Operation
and Service Manual, please contact Roberts-
Gordon Europe Limited.
1.1 Manpower Requirements
To prevent personal injury and damage to the
heater, two persons will be required for installation
.
1.2 Safety Labels and Their Placement
Product safety signs or labels should be replaced by
the product user when they are no longer legible.
Contact Roberts-Gordon for obtaining replacement
signs or labels.
See Page 2, Figure 1 through Page
3, Figure 2.
Figure 1: Front and Back Panel Label Placement
Description Part Number
Logo Label 91040030
Address Label 91040006
Lockout Reset Label 91038303
Rating Plate Label 91040001
Connection Diagram Label 91040022