Oki FAX 5050 User Manual
Page 40
28
Faxing: Dial Directories
7
Enter the Location ID. This is a descriptive title up to 16
characters long. Refer to the instructions below.
To Do This
Use
Enter numbers
Numeric keypad (press once)
Enter spaces
Space One Touch key
Enter hyphens (-)
Hyphen key
Enter alphabet characters
Locate the character you want on the numeric
keypad. Press that key repeatedly until the
character appears in the display.
Enter a unique character
Press the 0/Unique key repeatedly until
the character you want appears in the display.
The following characters are available: ! # & ‘ ( )
* + , - . / : ; = ? · д Я с ц ь Ж Е Ш ж е ш.
Enter two successive
Press the No ᮣ key to move to the next
letters/numbers on
character.
the same key.
Move the cursor to
Yes ᮤ and No ᮣ keys
make corrections
8
Press the Start key. The display shows
NO=<OR LOCATION> for about three seconds.
9
Enter the optional alternate fax number, if desired. Refer
to the instructions following Step 5.
1 0
Press the Start key to finish programming the
One Touch key. The display shows LOCATION
PROGRAMMING.
1 1
To continue programming One Touch keys, go
back to Step 3. If you are finished programming, press
the Select Function key.
1 2
Lift off the plastic cover above the One Touch label. Using
a pencil, write in the location name for your One Touch
key(s). Then replace the cover.
One Touch Parameters
If you are experiencing problems communicating with a
remote location in a very noisy telephone area, set up a
One Touch key for that location and try turning Echo
Protection on for that One Touch key. This helps the ma-
chine overcome noise and echo problems on the phone
line.
See the Problem Checklist sections for other suggestions.
1
Press the Select Function key.
2
Press the 9/User Program One Touch key.
The display shows 1:FUNC. PROGRAMMING.
3
Press the Yes
ᮤ key.
The display shows FUNCTION NO. [ ].
4
Using the numeric keypad, enter 23.
The display shows 23:ONE TOUCH PARAM
YES [OT] NO[
ᮣ
].
5
Press the One Touch key for the location whose
settings you want to change. The display shows ECHO
PROTECTION, [OFF].
6
Press the No
ᮣ
key to switch Echo Protection on.
7
Press the Yes
ᮤ key to confirm your selection.
The display shows 23:ONE TOUCH PARAM. [ ].
Of5050hw.pm6
4/15/98, 9:31 AM
28