Onkyo TX-SR876 - Manual (Page 102)

102
Advanced Setup
—Continued
Equalizer Settings
With the Equalizer settings, you can adjust the tone of
speakers individually with a 7-band equalizer. The vol-
ume of each speaker can be set on page 100. The Equal-
izer settings only apply to Speakers A and cannot be
adjusted while Speakers B is selected.
■ MultEQ XT
Audyssey MultEQ XT correction is active (see page 64).
■ Dynamic EQ
“Audyssey MultEQ XT” and “Dynamic EQ” becomes
active (see page 64).
■ Dynamic Vol(Light)
“Audyssey MultEQ XT”, “Dynamic EQ”, and
“Dynamic Volume (Light Compression Mode)”
becomes active (see page 64).
This setting prevents loud and soft sounds from being
much louder and softer respectively than average
sounds.
■ Dynamic Vol(Heavy)
“Audyssey MultEQ XT”, “Dynamic EQ”, and
“Dynamic Volume (Heavy Compression Mode)”
becomes active.
This setting affects volume the most, causing all sounds
to be of equal loudness.
1 Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2 Use the Up and Down [ ]/[ ] but-
tons to select “2. Speaker
Setup”, and then press [ENTER].
The “Speaker Setup” menu appears.
3 Use the Up and Down [ ]/[ ] but-
tons to select “5. Equalizer Set-
tings”, and then press [ENTER].
The “Equalizer Settings” screen
appears.
These settings are set automatically by the Automatic
Speaker Setup function (see page 64).
DISPLAY MUTING
GU
IDE EXI T
PREV
CH
DIMMER
CDR/MD/DOCK
SAT TAPE/AMP
SLEEP
REMOTE MODE
ENTER
TO P M ENU MEN
U
VOL
CH
DISC
ALBUM
TV
VCR
CABLE NET/USB
DVD
RECEIVER
CD ZONE 2
+
-
SE
TUP RET UR
N
1, 8
1
2-7
2. Speaker Setup
1. Speaker Settings
2. Speaker Config
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
MOVE ENTER RETURN ENTER RETURN EXIT SETUP
RETURN RETURN EXIT SETUP MOVE VALUE
2–5. Equalizer Settings
Equalizer
Channel
63Hz
160Hz
400Hz
1000Hz
2500Hz
6300Hz
16000Hz Manual
Front
0dB
0dB
0dB
0dB
0dB
0dB
0dB
4 Use the Left and Right [ ]/[ ]
buttons to set the “Equalizer”
option to:
Off: Equalizer off, flat response.
Manual: The equalizer for each
speaker can be set manually.
MultEQ XT
*1
Dynamic EQ
*1
Dynamic Vol(Light)
*1
Dynamic Vol(Heavy)
*1
*1 These setting can be selected after having
performed the Automatic Speaker Setup.
As soon as the Automatic Speaker Setup is
complete, it will automatically be set to
Dynamic EQ™.
When “Dynamic EQ” is selected,
“MultEQ
®
XT” and “Dynamic EQ”
become available.
When “Dynamic Vol(Light)” or
“Dynamic Vol(Heavy)” is selected,
“MultEQ XT”, “Dynamic EQ”, and
“Dynamic Volume
™
” become avail-
able.
If you selected “Manual”, continue
with the next step. If you selected “Off”
go to step 8.