Onkyo TX-SR876 - Manual (Page 98)

98
Advanced Setup
—Continued
Setting Speakers A and Speakers B
(TX-NR906 only)
If you’re using Speakers B, you can choose whether or
not to use the subwoofer, center, surround, and surround
back speakers with the Speakers A and Speakers B con-
figurations independently. You cannot choose whether
or not to use the front speakers.
Use the remote controller’s [SP A] or [SP B] button to
select Speakers A or Speakers B, respectively.
13 Press the Down [ ] button to dis-
play the bottom half of the
“Speaker Config” screen.
Notes:
• The bottom half of the “Speaker
Config” screen can only be displayed
when the “Speaker Type:
Front(Speaker B)” setting is set to
something other than “Not Use”
(page 61).
• You can switch between the Speak-
ers A and Speakers B settings on
either half of the “Speaker Config”
screen.
14 Use the Up and Down [ ]/[ ] but-
tons to select “Subwoofer”, and
then use the Left and Right
[
]/[ ] buttons to select:
Not Use: Select if you don’t want to
use the subwoofer with
Speakers A or Speakers B.
Use: Select if you do want to use
the subwoofer with Speakers
A or Speakers B.
Note:
Cannot be set if “Subwoofer” (step 5) is
set to “No”.
These settings are not set automatically by the Auto-
matic Speaker Setup function (see page 64).
RETURN RETURN EXIT SETUP MOVE VALUE
2–2. Speaker Config
Subwoofer
Front
Center
Surround
SurrBack Not Use
Use
Not Use
Use
Use
Speaker A
15 Use the Up and Down [ ]/[ ] but-
tons to select “Center”, and then
use the Left and Right [
]/[ ]
buttons to select:
Not Use: Select if you don’t want to
use the center speaker with
Speakers A or Speakers B.
Use: Select if you do want to use
the center speaker with
Speakers A or Speakers B.
Note:
Cannot be set if the “Center” (step 7) is
set to “None”.
16 Use the Up and Down [ ]/[ ] but-
tons to select “Surround”, and
then use the Left and Right
[
]/[ ] buttons to select:
Not Use: Select if you don’t want to
use the surround speakers
with Speakers A or Speakers
B.
Use: Select if you do want to use
the surround speakers with
Speakers A or Speakers B.
Note:
Cannot be set if the “Center” (step 8) is
set to “None”.
17 Use the Up and Down [ ]/[ ] but-
tons to select “SurrBack”, and
then use the Left and Right
[
]/[ ] buttons to select:
Not Use: Select if you don’t want to
use the surr back speakers
with Speakers A or Speakers
B.
Use: Select if you do want to use
the surr back speakers with
Speakers A or Speakers B.
Note:
• Fixed at “Not Use” if “Surround”
(step 16) is set to “Not Use”.
• Cannot be set if “Speaker Type:
Front(Speaker B)” is set to
“Bi-Amp” or “BTL” (page 61),
“SurrBack” is set to “None” (step 9),
or “Powered Zone2” is being used
(page 132).