Advanced setup —continued – Onkyo TX-SR876 User Manual
Page 106
106
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
Tone Control Settings
You can adjust the tone (bass and treble) of the front,
center, surround, and surr back speakers individually.
For the subwoofer, you can adjust the bass.
■ Bass
You can boost or cut low-frequency sounds from –10 dB
to +10 dB in 1 dB steps.
■ Treble
You can boost or cut high-frequency sounds from
–10 dB to +10 dB in 1 dB steps.
Notes:
• The tone control circuits are bypassed when the
Direct, Pure Audio or THX listening mode is selected.
• This setting is not available when the multichannel
Analog input is selected.
• This procedure can also be performed on the AV
receiver by using its [TONE], [
], and [
] buttons
DSD Setting
■ DAC Direct
This setting determines whether or not DSD (SACD)
audio signals are passed through the DSP for A/V Sync,
delay, etc., processing when the Pure Audio or Direct lis-
tening mode is selected.
No: DSD signals are processed by the DSP
(default).
Yes: DSD signals are not processed by the DSP.
Multiplex/Mono Settings
Multiplex
■ Input Ch(Mux)
This setting determines which channel of a stereo multi-
plex source is output. Use it to select audio channels or
languages with multiplex sources, multilingual TV
broadcasts, and so on.
Main: The main channel is output (default).
Sub: The sub channel is output.
Main/Sub: Both the main and sub channels are output.
Mono
■ Input Ch(Mono)
This setting specifies the channel to be used for playing
any 2-channel digital source such as Dolby Digital, or
2-channel analog/PCM source in the Mono listening
mode.
L+R: Both the left and right channels are output
(default).
L: Only the left channel is output.
R: Only the right channel is output.
■ Output Speaker
This setting determines which speakers output mono
audio when the Mono listening mode is selected.
C: Mono audio is output by the center speaker
(default).
L/R: Mono audio is output by the front left and right
speakers.
PLIIx/Neo:6 Settings
PLIIx Music(2ch Input)
These settings apply to only 2-channel stereo sources.
If you’re not using any surround back speakers, these
settings apply to Dolby Pro Logic II, not Dolby Pro
Logic IIx.
■ Panorama
With this setting, you can broaden the width of the front
stereo image when using the Dolby Pro Logic IIx Music
listening mode.
On: Panorama function on.
Off: Panorama function off (default).
5
When you’ve finished, press the
[SETUP] button.
The setup menu closes.