Onkyo TX-SR876 - Manual (Page 103)

103
Advanced Setup
—Continued
Notes:
• When the listening mode is set to Direct or Pure
Audio, no effect will be produced.
• The Equalizer settings have no effect on 176.4/
192 kHz input signals.
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
5 Use the Down [ ] button to select
“Channel”, and then use the Left
and Right [
]/[ ] buttons to
select a speaker.
You can select: “Front”, “Center”,
“Surround”, “SurrBack”, or “Sub-
woofer”.
6 Use the Up and Down [ ]/[ ] but-
tons to select a frequency, and
then use the Left and Right
[
]/[ ] buttons to adjust the
level at that frequency.
You can select: “63Hz”, “160Hz”,
“400Hz”, “1000Hz”, “2500Hz”,
“6300Hz”, or “16000Hz”. And for the
subwoofer, “25Hz”, “40Hz”, “63Hz”,
“100Hz”, or “160Hz”.
The volume at each frequency can be
adjusted from –6 to +6 dB in 1 dB
steps.
Tip:
Low frequencies (e.g., 160Hz) affect
bass sounds; high frequencies (e.g.,
6300Hz) affect treble sounds.
7 Use the Up and Down [ ]/[ ] but-
tons to select “Channel”, and
then use the Left and Right
[
]/[ ] buttons to select another
speaker.
Repeat steps 6 and 7 for each speaker.
8 Press the [SETUP] button.
The setup menu closes.
RETURN RETURN EXIT SETUP MOVE VALUE
2–5. Equalizer Settings
Equalizer
Channel
63Hz
160Hz
400Hz
1000Hz
2500Hz
6300Hz
16000Hz Manual
Front
0dB
0dB
0dB
0dB
0dB
0dB
0dB