Omega Vehicle Security Wireless Sensor System zSeries - Manual (Page 15)

9
2.1e Parts of the End Device (zED)
1 8 position DIP switch (under cover), sets the NID and DID of the End
Device (see Section 2.7 for details)
2 Power Switch
3 Label for Unit Address, Group No. and Network ID address (NID)
4 Wall mounting holes
5 Label with model and serial numbers
6 Radio module firmware revision location on label
7 Case’s tray, where the PCB, sensor and batteries are mounted
8 Case’s cover
9 Transmit LED (blue)
10 Case’s latch: squeeze sides to pull the cover off
11 Cable for optional external probe with sensor
12 Optional rear entry for external probes
Figure 2.1e Parts of the End Device (zED)
FRONT REAR
11
9
2
10
7 8
MODEL #
SERIAL #
#.#
1
4
3
5
6
12
Unit Addr Group Net. Addr