Omega Vehicle Security Wireless Sensor System zSeries - Manual (Page 34)

28
3.5.2 Changing TCP/IP Properties on Your Computer
Go to your computer’s Control Panel then Network Connections.
Pick the network with the proper Ethernet card. Right click and choose Properties.
Figure 3.2 Network Connections
Setup the IP address (in this case, 192.168.1.1) as shown below and press OK.
Figure 3.3 Network Connections
Look for Internet Protocol Version 4
(TCP/IPv4), click on it and press Properties
You can access the Coordinator’s web
server via any internet browser using IP
address of 192.168.1.200.
Once you log into the Coordinator’s
web server, you will be able to change
its IP configuration according to
Section 4.2.
After you configure the
Coordinator’s IP configurations,
you should go back and set
your PC’s previous IP settings.