Omega Vehicle Security Wireless Sensor System zSeries - Manual (Page 30)

2.7.3 DIP Switch Setup: Ethernet - Coordinator
Figure 2.9 Ethernet - 4 Position DIP Switch Setup
To set the Coordinator to factory default settings:
1) Slide DIP switch #2 to ON position.
2) Power the Coordinator on and wait about 10 seconds until the Coordinator
fully boots up.
3) Set the DIP switch #2 back to OFF position (it does not matter if the
Coordinator is powered ON or OFF, just make sure that the DIP switch is set
to OFF, otherwise, every time the unit is power-cycled the factory settings will
take over).
OFF ON
1
8
1 SERIAL 2 DEF
AUL
T
3 DHCP 4 TERMINAL
OFF
ON
1 4
(Shown in
"OFF" Position)
24
1) N/C
2) To change Ethernet settings
to factory default
3) To enable/disable DHCP
4) N/C
Coordinator
Rear View