Onkyo USR-5RF - Manual (Page 31)

31
Getting the Maximum out of it
Editing macros
You can edit any macro you have recorded.
1. Open the macro group that contains
the macro.
2. Switch to Edit mode via the Mode
button.
3. Tap the macro you want to edit.
The contents of the macro appear.
Setting timers
To activate a device at the time you set.
1. Tap the Macro menu button.
2. Open the macro menu and select a
timer group.
3. Switch to Edit mode by using the
Mode button.
Empty timer buttons appear in the timer
control panel.
4. Tap the button you want to set a timer
for.
The first timer control panel appears in which
you can set the start time.
4. Edit the macro.
You can move or delete listed commands or
you can add new commands. You can also
add delays to the macro (for example, to
insert a short pause between turning on a
device and sending commands to it allowing
the device to warm up):
1. Tap Delay.
2. Tap or to decrease or increase the
length of the delay.
3. Use the arrow buttons and to move
the delay to the right place.
5. Press the Left button to close the
macro.
A confirmation screen appears, which allows
you to save or cancel the macro.
6. Tap Save.
The macro is ready to be used.
5. Enter the command the timer has to
execute.
A timer can contain either a single IR
command or a macro.
You can navigate to any control panel you
want, just as you can in Use mode.