SUUNTO Stinger - Manual (Page 78)

76
3. Press S to change the selection in the following
sequence.
-> On/OFF status -> depth alarm limit -> dive time
alarm minutes (-> dive time alarm seconds)
4. While the alarm status [On/OFF] is selected
(blinking), press + or - to change the status. When the
alarm status is On, the depth alarm indicator ( -
symbol) in the bottom right corner of the display
indicates that the alarm is on.
5. While the depth digits are selected (blinking), press
+ to increase the value or - to decrease it at intervals of
0.5 m [1 ft]. Holding down either button starts the
scrolling of the depth value. The range of the depth is
from 3.0 to 150 m [10 to 450 ft]. The default setting is
40m [131ft]. If set to 0, the alarm is disabled.
6. While the dive time minutes are selected (blinking),
press + or - to change the time. If the time is less than
five (5) minutes, the dive time alarm seconds can also
be set. This feature can be used for freediving (Fig.
4.13.)
7. After you have set the depth alarm, press the M button
to save the settings and to return to the Setting Mode
[SET].
Fig. 4.16. Setting Altitude
Adjustment.
Fig. 4.15. Adjustment Mode.