Maintenance – SUUNTO Stinger User Manual
Page 93
91
6.2. MAINTENANCE
If left without care for an extended period, a thin film (often invisible to the eye) will
cover the unit. Much like the buildup on the glass of an aquarium, this film is the
result of organic contaminates found in both salt and fresh water. Suntan oil, silicone
spray and grease will speed up this process. As a result of this buildup, moisture will
be trapped next to the water contact and will not allow your Stinger to operate properly.
The water contact can be cleaned with a small brush (e.g. toothbrush).
IMPORTANT: The Stinger should be soaked, then thoroughly rinsed with fresh
water and then dried with a soft towel after each dive. Make sure that all salt crystals
and sand particles have been flushed out. Check the mineral crystal for possible
moisture or water. DO NOT use the Stinger if you detect any moisture or water
inside.
CAUTION!
do not use compressed air to blow water off the unit
do not use solvents or other cleaning fluids that might cause damage
do not test or use the Stinger in pressurized air.