Ositech comm 614006-001 - Manual (Page 38)

3 - 18 Trumpcard Ethernet LAN
Section Three
Loading the DOS ODI Driver
The DOS ODI driver OTCETH.COM for the Trumpcard PC Card is an
executable DOS TSR (Terminate and Stay Resident) program.
It must be loaded always after the LSL (Link Support Layer) module and
before the IPXODI (IPX Stack Protocol).
An example of a possible AUTOEXEC.BAT file allowing the loading of
necessary modules to establish a link from a DOS Workstation to a
Netware Server is:
LSL
OTCETH
IPXODI
NETX or VLM
Note: If your Ethernet frame type is NOT 802.2, you must use the NET.CFG
file to supply the appropriate frame type. The OTCETH driver will
default to 802.2 in accordance with Novell's specifications.
Note: Keyword specifications associated with the ODI drivers are explained
in Appendix A, Error Messages in Appendix C.
Novell Netware for OS/2
When installing Netware for OS/2, you may use the automatic installation
for the Ositech Trumpcard ODI device driver.
Netware 3.x and 4.x
1. Follow the instructions in the Netware Requester for OS/2
manual on how to Install and Configure the Novell Netware
OS/2 Requester.
2. During installation of the requester, when prompted for the
Network Interface Card Driver, enter OTCETH.SYS .
3. The installation utility will confirm if this is a third party NIC
driver, enter YES
4. When prompted to enter the file to install, enter
A:\NETWARE\OS2\OTCETH.SYS
Insert the Trumpcard driver diskette into Drive A.
5. Continue with the Netware requester installation, the final step
will be to configure the NET.CFG file. See Appendix A for ODI
keywords.
End of Installation.