Ositech comm 614006-001 - Manual (Page 48)

4 - 6 Trumpcard Ethernet LAN
Section Four
INTERRUPT= <interrupt level>
Description: Set the interrupt level
Default: 5 or AUTO
Accepted values: Any valid interrupt value excluding 0, 1, 2, 6, 8, and 13
Note: If this keyword exists, the driver will return an error if unable to operate
using the specified interrupt. If the keyword does not exist, the default
interrupt level will be 5 if Card Services is not present; otherwise the
first available interrupt obtained from Card Services will be used.
IOBASE= <I/O port>
Description: Set the I/O port
Default: 300 or AUTO
Accepted values: Any location within a 64 port boundary (300 and up in
increments of 40, with the upper limit dictated by the individual machine)
Note: If this keyword exists, the driver will return an error if unable to operate
using the specified I/O port. If the keyword does not exist, the default I/
O port will be 300 if Card Services is not present; otherwise the first
available I/O port obtained from Card Services will be used.
NETADDRESS= <‘nnnnnnnnnnnn’>
Description: Station address used to override the default PROM value.
Default: None ( driver uses PROM)
Accepted values: Valid hexadecimal for a Station Address according to
Ethernet pattern.
SOCKET= <socket number>
Description: Enable operation with PCMCIA socket indicated
Default: Auto
Accepted values: 1, 2, or Auto
Note: Specifying a socket number will limit the driver to only checking that
socket for the presence of a Trumpcard.
MAXTRANSMITS= <transmits>
Description: Maximum transmit queue blocks
Default: 4
Accepted values: Any value between 4-40 inclusive